The Hidden Fire Risk in Cheap EV Charger Installs
A Growing Problem in Ontario
As EV adoption accelerates across Ontario, so does the demand for fast, cheap charger installations. Unfortunately, some unlicensed contractors and DIY-ers are taking dangerous shortcuts that create serious fire hazards.
The Three Most Dangerous Shortcuts
1. Undersized Wire
The most common and deadly mistake is using wire that's too thin for the amperage. A 40-amp circuit requires 8 AWG wire at minimum. Using 10 AWG (which looks almost identical) causes the wire to heat up under load. Over months of nightly charging, this heat degrades the wire insulation and can ignite surrounding materials.
2. Loose Connections at the Panel
Every connection in your electrical panel must be torqued to the manufacturer's specification. A loose lug on a 40-amp breaker creates resistance, and resistance creates heat. This is especially dangerous inside a panel box, where there's little ventilation and plenty of flammable material.
3. Skipping the Dedicated Circuit
Some installers will connect an EV charger to an existing circuit rather than running a new dedicated one. This overloads the breaker and wiring whenever the charger runs simultaneously with other loads on that circuit — a guaranteed path to overheating.
What a Proper Installation Looks Like
A licensed installation from JSpec Electrical Contracting includes:
- Panel capacity assessment — confirming you have room for the new load
- Dedicated 40A or 50A circuit — run with properly sized wire from your main panel
- Torque-verified connections — at both the panel and the charger
- ESA permit and inspection — an independent safety check before the circuit is energized
- GFCI protection — shock protection built into the circuit
The Bottom Line
Your EV charger will run for 6–10 hours every night. That's more continuous electrical load than almost anything else in your home. Don't let the "installation" cost tempt you into a risk that could cost you everything.
